Table of Contents
Advertisement
PACKAGE CONTENTS
The robotic lawn mower package contains the following items.
Robotic lawn mower
Charging base
Power adapter
Perimeter wire
Nails for the charging base
Stakes
Flat spanner
User manual
Spare blade
Wire gauge
FUNCTIONS
Working Area
The robotic lawn mower is recommended for use on lawns with a maximum area as specifi ed in the Technical Specifi cations section.
The effi ciency of the robotic lawn mower depends on the condition of its blades, as well as the type, height, and moisture level of the grass. The garden layout is also
important. The robotic lawn mower can cover more area in an hour if the garden consists mostly of open lawns compared to gardens with small lawns separated by
trees, fl ower beds, and pathways.
A fully charged robotic lawn mower can run for 60 to 120 minutes, depending on the battery capacity, its age and the density of the grass. Afterwards, the lawnmower
will recharge for 90 to 150 minutes. Charging times may vary depending on, among other things, the ambient temperature.
Cutting Technique
The cutting system of the robotic lawn mower is based on an effi cient and energy-saving principle.
Equipped with a patented cutting system, the lawn mower produces small grass clippings that quickly decompose and serve as fertiliser.
To achieve the best results, it is recommended to let the lawn mower operate mainly in dry weather.
The lawn mower can cut in the rain or high humidity, but wet grass may stick to the lawnmower, and there is an increased risk of slippage on steeper slopes.
In the event of a storm, disconnect the power adapter from the power source and the perimeter wire from the charging base.
To maintain optimal cutting results, keep the blades in good condition. It is important to keep the lawn free of branches, small stones and other objects for the blades to
remain sharp.
Regularly replace the blades to get the best results. Replacing blades is very easy. See "Blade Replacement" on page 26.
Operating Mode
The robotic lawn mower cuts the lawn automatically. It alternates between charging and cutting phases.
When the battery level is too low, the lawn mower starts searching for the charging base.
If you leave the rain sensor in the factory setting, i.e. Enabled (switched on), the robotic lawn mower will start searching for the charging base. Mowing will resume
several hours after the rain stops.
When searching for the charging base, the lawn mower does not cut immediately but searches for the perimeter wire in an irregular motion. It then follows the perimeter
wire clockwise, locates the charging base, parks in it and the battery begins to charge.
Once ready for the next task, the lawn mower leaves the charging base automatically and resumes operation.
The control panel under the cover on the top of the robotic lawn mower is where you can change all the settings of the robotic lawn
mower.
Opening the control panel cover while the lawn mower is operating stops it instantly. However, it's recommended to press the STOP
button before opening the control panel cover.
The STOP button on the top of the robotic lawn mower is mainly used to stop the robotic lawn mower when it is running.
IMPORTANT INFORMATION
You can stop the robotic lawn mower at any time by pressing the STOP button.
ROBOTIC LAWN MOWER
FZRR 5650-A
FZRR 5950-A
150 m
200 m
4 pcs
4 pcs
150 pcs
200 pcs
3 pcs
3 pcs
9
EN
Introduction
USER MANUAL
Advertisement
Table of Contents
