NOTE
Please heed the level-shifting of the connection shown in dotted line between the module and the host.
3.1.2. Airplane Mode
The module provides W_DISABLE# to disable or enable airplane mode via hardware operation.
W_DISABLE# is pulled up by default. Driving it low will bring the module into airplane mode.
Table 7: Pin Description of W_DISABLE#
Pin Name
Pin No.
W_DISABLE#
151
In airplane mode, the RF function is disabled by default, but it can also be enabled or disabled through
AT commands. The following table shows the RF function status of the module.
Table 8: RF Function Status
W_DISABLE#
Logic Level
High Level
Low Level
NOTE
1.
W_DISABLE# for airplane mode control function is disabled by default. It can be enabled through
executing AT+QCFG="airplanecontrol"*.
2.
The execution of AT+CFUN command will not affect GNSS function.
3.
See document [4] for details about related AT commands mentioned in the above table.
EG060K &EG120K _Series_Hardware_Design
103
I/O
Description
DI
Airplane mode control
AT Command
AT+CFUN=1
AT+CFUN=0
AT+CFUN=4
AT+CFUN=0
AT+CFUN=1
AT+CFUN=4
RF Function Status
Enabled
Disabled
Disabled
Disabled
LTE-A Module Series
Comment
Pulled up by default.
In low level, the module will
enter airplane mode.
If unused, keep it open.
Operating Modes
Full functionality
Minimum functionality
Airplane mode
Airplane mode
33 /