Table of Contents
Advertisement
Chapter 12. Appendix
Troubleshooting
If there is no sound, or if the XP-10 does not function
as you expect, first check the following points. If this
does not resolve the problem, contact your dealer or
qualified Roland service personnel.
Power does not turn on
Is the AC adaptor correctly connected to an AC out-
let and to the XP-10?
Check the AC adaptor connections.
No sound / Volume is weak
Is the power turned on for the other devices which
are connected?
Make sure that the power is turned on for your
amp/mixer system.
Is the volume turned down?
Check the volume of the XP-10 and the volume of
your amp/mixer system.
Is there sound in the headphones?
If there is sound in the headphones, the problem may
be that the connecting cables are broken or that the
amp or mixer is malfunctioning. Check the cables and
equipment once again.
Is ROM Play mode selected?
Either
simultaneously
press
VALUE[+]
and
[USER/PRESET], or press [EXIT] to exit ROM Play
mode.
Is Local Control turned off?
Turn Local Control ON (p.44).
Are the volume (Level) settings of the Performance
and of each Part turned down?
Check the Performance Level (p.50) and each Part
Level (p.60) setting.
Has a Volume message from an external device
turned down the volume setting of a Part?
Set the Level (p.60) of the Part.
Does the Transmit Channel match the Receive
Channel?
Check the Transmit Channel (p.45) and the Receive
Channel (p.45).
Has a Tone or Drume Set which does not exist on
the XP-10 been selected using an external device?
Check the Tone or Drum Set list (p.71, p.74), and re-
select the Tone or Drum set.
Pitch is incorrect
Has Transpose been turned on?
Press [TRANSPOSE] to turn it off.
Is the Key Shift setting correct?
Check the setting (p.27).
Is Scale Tune turned on?
Turn off Scale Tune (p.33).
Is the Master Key Shift setting correct?
Check the setting (p.48).
Is the Master Tune setting correct?
Check the setting (p.15).
Has a Pitch Bend message been received from an
external device, causing the pitch to "stick"?
Move the Pitch Bender.
Cannot select Tones
Is Local Control turned off?
Turn on Local Control (p.44).
Is the Tone Change Receive Switch turned off?
Turn on the Tone Change Receive Switch (p.45).
Effects (Chorus/Reverb) are not
applied
Is the Chorus Level / Reverb Level or the Chorus
Depth / Reverb Depth set too low?
Check the settings of Chorus Level / Reverb Level
(p.25) and Chorus Depth / Reverb Depth (p.25).
63
Advertisement
Table of Contents
