Creatine A: Drum Sel Ccdicnnduaccredsanndocnrecascunbesttenstnaarsruasedentaeuteaceiectort Vans Hictevena Monauerimtamsenele Aes; Saving A Moditied: Diuin S E T E S C S S I T I T A C E T C H Y Metastases Nen Cnbroninadamsei Oases - Roland XP-10 Owner's Manual

Chapter 4. Creating your own Tone or Drum Set
Creating a Drum Set
After using the following procedure to modify a
Drum Set, be careful not to select a Drum Set. If you
select a Drum Set before saving your edits, your
changes will be lost.
1. Select the Drum Set that you wish to modify
("Selecting a Drum Set" p.18).
You may select either a Preset Drum Set or a User
Drum Set.
2. Press [EDIT].
The indicator will light.
3. Use VALUE[-]/[+] to select "Tone/Drum" and
press [ENTER].
4. Press [4] several times to select the parameter you
wish to edit.
* If you hold down [ENTER] while you press [4], you
will return to the previous item.
5. Press a note on the keyboard to select the percus-
sion instrument that you wish to modify.
Percussion Sound Name
Note Name
High Bongo c4
Pitch: +10
Parameter Value
* If you wish to modify the drum sound of a key
which is outside the range of the keyboard, use the
Transpose function (p.27) to shift the range of the
keyboard.
6 Use VALUE[-]/[+] to set the values of the para-
meters.
* If you wish to set the value of other parameters,
repeat steps 4-6.
* If you wish to modify other percussion instruments
in the Drum Set, repeat steps 4-6.
7. Press [EDIT].
The indicator will go off, and the previous display
will reappear.
36
Saving a modified Drum Set
The modified Drum Set can be saved in one of 20
locations (1-20 of User). Be sure to save your Drum
Set to a destination that contains a User Drum Set that
you do not need to keep.
* Tf you turn the power off without saving the Drum
Set, the Drum Set settings you made will be lost.
8. Press [UTILITY].
The indicator will light.
9. Use VALUE[-]/[+] to select "Write Tone/Drum"
and press [ENTER].
10. Use the numeric keys ([1]-{0]) to specify the sav-
ing destination Drum Set number (1-20).
If you make a mistake, press [CANCEL] and enter the
number once again.
* You can also specify the Drum Set number using
VALUE[-]/[+] instead of the numeric keys. In this
case, there is no need to press [ENTER] in step 11.
11. Press [ENTER] to finalize the number.
* To cancel the operation, press [UTILITY]. The indi-
cator will go out, and the previous display will
reappear.
12. Press [ENTER] once again, and the edited Drum
Set will be written into memory.
When the Drum Set has been written into memory,
the display will indicate "Completed." The [UTILITY]
indicator will go off, and the previous display will
reappear.