Choosing The Program - Smeg CWG410M Manual

WARNING! If the appliance is connected to cold water, wait at least 15' before moving on to the
next phase to give the tank time to reach the correct washing temperature.
When the door is closed again, the last program is repeated.
8.4 Choosing the program
PROGRAM
Short Glasses and cups
Medium Glasses, cups and plates with light dirt
Long Very dirty dishes and cutlery
(*) The cycle duration stated above is guaranteed if the appliance is connected to hot water > 50°C
<60°C
If the dishwasher is supplied with cold water, the cycle duration might increase depending on the
intake water temperature and the "thermostop" setting.
‐ CWG410 ‐
The dishwasher fills the tank automatically. At the
end of this phase, when the tank is full, P appears
on the display and program lights L5, L6 and L7are
lit.
Load the dishes and close the door.
Select the programme required by pressing one of
the three buttons; the LED of the selected program
flashes and the other two go out. The cycle starts
once the key has been held down for about 2".
While washing is in progress the display shows the
water temperature in the tank. During rinsing, it
shows the boiler temperature.
At the end of the program the program LED comes
on and "End" flashes on the display.
Unload the dishes
TYPE OF DIRT
22
DURATION (*)
Short 2'
Medium 2.5'
Long 3'