Malfunctions Shown On The Display (For The User) - Smeg CWG410M Manual

PROBLEM
DISHES NOT PROPERLY
DRIED
11 MALFUNCTIONS SHOWN ON THE DISPLAY (FOR
The dishwasher is able to identify a number of malfunctions and show them on the display.
If the problem persists after the dishwasher has been switched off and back on, proceed as described
below:
E.1 Boiler temperature probe malfunction
E.2 Tank temperature probe malfunction
E.3 Water intake malfunction
E.4 Boiler overheating.
E.5 Tank overheating
E.6
Water not pumped out of tank
‐ CWG410 ‐
POSSIBLE CAUSE
Low rinsing temperature due to
thermostop OFF and/or water
intake temperature below 50°
THE USER)
connection diagram.
Check that the water supplying the
appliance is at least at 50°
If the problem persists call the after‐
sales service
Switch the dishwasher off and back on and perform
another cycle; if the problem persists call the after‐
sales service
Switch the dishwasher off and back on and perform
another cycle; if the problem persists call the after‐
sales service
Water intake not completed in the maximum time
allowed
Check dynamic pressure in intake system: the water
intake filter may need cleaning, the tap may be
turned off or the rinsing nozzles may be fouled.
Switch the dishwasher off and wait a few minutes,
then switch back on and perform another cycle
If the problem persists call the after‐sales service.
Switch the dishwasher off and wait a few minutes,
then switch back on and perform another cycle.
If the problem persists call the after‐sales service.
Inspect the filters for dirt and check that the drain
hose is not blocked, bent or crushed.
Check that the drain pump is not blocked by dirt by
removing the insert on the sump (from inside the
tank, see photo)
If the system fails to pump out because the drain
pump is fouled (as a result of incorrect filter
positioning), proceed as follows:
Bale out the dishwasher with a basin and disconnect
28
POSSIBLE REMEDY