Table of Contents
Advertisement
Figure 29. Installing the M.2 2230 solid-state drive
Steps
1. Ensure that the thermal pad covering the M.2 2230 slot on the system board is in place.
2. Align the notch on the solid-state drive with the tab on the M.2 card slot.
3. Slide the solid-state drive into the M.2 card slot on the system board.
4. Replace the screw (M2x3.5) that secures the solid-state drive to the system board.
Next steps
1. Install the
system-board
2. Install the
I/O
cover.
3. Install the
back
cover.
4. Install the stand.
5. Follow the procedure in
Memory module
Removing the memory module
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
5. Remove the
system-board
About this task
The following image indicates the location of the memory module and provides a visual representation of the removal procedure.
shield.
After working inside your
Before working inside your
shield.
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
53
Advertisement
Table of Contents
