Table of Contents
Advertisement
52
3
Remove the four tray screws to open the drive tray. Keep the
screws for later use.
4
When applicable, pull out any previously installed hard disk.
5
Install a hard disk on the drive tray then secure it with the four
tray screws you have removed earlier.
6
Insert the tray into the hot-swap cage with the lever still extended.
Make sure that the drive is properly inserted before closing the
lever.
7
Push the lever back until it clicks into place.
Replacing a 5.25-inch storage device (optional)
Note: If you are installing a new drive in an empty drive bay, skip
steps 2 to 4.
To replace a 5.25-inch storage device:
1
Remove the housing panels. Refer to page 38 for more detailed
instructions.
2
Detach the power and signal cables from the drive.
Download from Www.Somanuals.com. All Manuals Search And Download.
3 Upgrading your system
Advertisement
Table of Contents
