Installation And Disassembly Of Heat Discharge Pipe - Gree GPC07AQA-K5NNA1A Owner's Manual

Installation and disassembly of
heat discharge pipe
Install heat discharge pipe
1. Rotate joint and Rear clip clockwise into
the two ends of heat discharge pipe.
clockwise
joint
heat discharge pipe
2. Insert joint of heat discharge pipe (the side with
"TOP" is upwards) into the groove until you hear
a sound.
clasp
groove
3. Lead the heat discharge
pipe outdoors.
4. Slide and open the exhaust cover on the window
panel, and attach the Rear clip. (Optional)
clockwise
Rear clip
the side with "TOP" is upwards
Note of Installing heat discharge
pipe
In order to improve cooling efficiency,the heat
discharge pipe should be as short as possible
and flat without curve to ensure smooth heat
discharge.
The discharge pipe is suggested to be installed accord-
ing to below figure by the manufacturer.
correct
User can adjust the installation method of the discharge
pipe basing on the requirement, while the similar
installation methods as below which will lead to
unsmoothly air-out are not allowed.
wrong
● The length of the heat discharge pipe is less than
40 inches. It is recommended to use it with shortest
length.
● When installing,heat discharge pipe should be as
flat as possible. Don't prolong the pipe or connect it
with other heat discharge pipe.
20
under 130cm
about 61cm