Service Manual
8.3 Installation and Disassembly of heat Discharge Pipe
A. Install heat discharge pipe
(1) Rotate joint A and joint B clockwise into the two ends of heat discharge
pipe.(As show in Fig.10)
(2) Insert joint A of heat discharge pipe (the side with "TOP" is upwards) into
the groove until you hear a sound.(As shown in Fig.11)
(3) Lead the exhaust hose outdoors.(As shown in Fig.12)
clasp
groove
Note of Install heat discharge pipe
In order to improve cooling efficiency, the heat discharge pipe should be as short as possible and flat without curve to ensure smooth
heat discharge.(As shown in Fig.13)
●The length of the heat discharge pipe is less than 1m. It is recommended to use it with shortest length.
●The length of the heat discharge pipe is less than 1m. It is recommended to use it with shortest length.(As shown in Fig.14)
correct
correct
●Correct installation is as shown in figure (When installing it on wall, height of hall should be about 40cm-130cm from floor).(As shown
in Fig.15)
●Wrong installation is shown in following figure (If the pipe is bent too much, it would easily cause malfunction.(As shown in Fig.16)
Fig.15
Maintenance
the side with "TOP" is upwards
Fig.11
correct
wrong
Fig.13
clockwise
joint A
heat discharge pipe
Fig.14
Fig.16
clockwise
joint B+C
Fig.10
Fig.12
25