Keysight U1701B Operating Instructions Manual page 9

Actions
To cycle through 1%, 5%, 10% and 20% tolerance
– will be indicated.
– Beeper will beep once if the test value is within the
selected tolerance. If the test value is out of the
tolerance, the beeper will beep three times.
– This mode cannot be enabled under the following
conditions:
– After setting the recording mode
– After setting the compare mode
– Display showing either OL or below 10 counts
To enable compare mode
– Measuring range will be locked
– will be displayed and the secondary display
will indicate C # #, meaning which set has been
used for compare mode. The two right digits
indicate current compare set. The # # range from
01 to 25.
– The primary display shows the present
measurement. In this state, it is ready for testing.
– If the reading is beyond the high limit,
indicated. will be indicated if the reading is
out of the low limit. The beeper will beep three
times and the secondary display will indicate nGo.
– If the reading is within the high and low limits, the
beeper will beep once, and the secondary display
will indicate Go. After three seconds or when the
reading is lower than 10 counts, the instrument
will return to its ready state.
– The secondary display will indicate C01 to C25
according to the comparison record that has been
selected.
To save comparison set for next entry
Keysight U1701B Quick Start Guide
Steps
Press
momentarily
Press
will be
Press
hold for more than 1 s
and
9