Keysight U1701B Operating Instructions Manual page 10

Actions
To exit compare mode
To view the High/Low limit value to be used as
compare mode
To cycle through HI limit, LO limit, and present values
on the primary display
– The secondary display showed as H # #, L # # and
C # # respectively.
– After three seconds without pressing this button
again, it will return to the present value display.
To toggle HI and LO limits for adjustment
To enter HI/LO limits setting mode
– The secondary display will flash H01 and the
primary display will indicate the value of HI limit.
– The following buttons will be used for this setting
mode:
– To select which digit to be adjusted
– To increase or decrease the current digit's
value
– To select High or Low limit to be set.
– To store the setting value in the memory. The
beeper will beep twice if the selected value has
been stored. If the current setting do not meet
the rule that the high limit must be equal or
greater than the low limit, the beeper will beep
three times.
– To select next compare setting. To cycle
through L01 (or H01) to L25 (or H25), then
return to L01 (H01) setting.
10
Steps
Press
Press
momentarily
Press
Press
momentarily
Press
more than 1 s
Press
(Right)
Press
(Down)
Press
Press
more than 1 s
Press
momentarily
Keysight U1701B Quick Start Guide
for
(Left) or
(Up) or
for