Keysight U1701B Operating Instructions Manual page 8

Actions
To enable relative function
– Relative function shows the difference between
the measured value and the offset reference value.
The display may show a non-zero value due to the
presence of test leads. Use the relative function to
nullify the residual.
– Relative function can operate in both auto and
manual ranging mode but the function cannot be
set when an overload value exists.
– REL annuciator will be displayed.
To renew the relative value
To exit relative mode
To select manual range and to turn off the AUTO
annunciator
To step up a range at a time
To select auto-range
– In auto range mode, the AUTO annunciator is
displayed and the instrument will select an
appropriate range for resolution if the reading is
greater than the maximum available range. OL will
be displayed.
– The instrument will select a lower range when the
reading is less than 9% of full scale.
To enable the tolerance mode and to set the display
value as a standard reference
– TOL annunciator will be displayed.
– The tolerance will be displayed on the secondary
display.
– The instrument range will be locked.
To exit tolerance mode
8
Steps
Press
Press
Press
more than 1 s
Press
Press
Press
more than 1 s
Press
Press
hold for more than 1 s
Keysight U1701B Quick Start Guide
again
for
again
for
and