Table of Contents
Advertisement
Engine Oil
Oil Level Inspection
•
If the engine is cold, start the
engine
and run it for several
minutes at idle speed.
•
Stop the engine, then wait
several
minutes until the oil
settles.
NOTICE
Racing the engine before the oil
reaches every part can cause en-
gine seizure.
•
Check the engine oil level through
the oil level inspection window.
With the motorcycle held level,
the oil level should come up
between the upper and lower
level lines next to the oil level
inspection window.
•
When installing the oil filler cap,
replace its O-ring with a new one.
Oil and/or Oil FilterChange
•
The oil change and oil filter
replacement should be done by
an authorized Bimota dealer.
A.Oil Level Inspection Window
B.Oil Filler Cap
C.Upper LevelLine
D.Lower Level Line
•
If the oil level is too high, remove the excess oil
through the oil filler opening using a syringe or
some other suitable device.
•
If the oil level is too low, add oil to reach the
correct level. Use the same type and brand of
oil that is already in the engine.
A.Engine Oil DrainBolt
B.Oil Filter
Tightening Torque
Engine Oil Drain Bolt:
25 N·m (2.5 kgf·m, 18 ft·lb) Oil
Filter:
17 N·m (1.7 kgf·m, 13 ft·lb)
17
Advertisement
Table of Contents
