Basic Dimensions Of The Router Box; Mounting Recommendations - Advantech SmartMotion ST352 Hardware Manual

3. Router Design

3.5 Basic dimensions of the router box

3.6 Mounting recommendations

• Possibility to be put on a work surface,
• DIN rail EN 60715 with included metal clip.
For the most of applications with a built-in router in a switch board it is possible to recognize two kinds of
environments:
• No public and industry environment of low voltage with high interference,
• Public environment of low voltage without high interference.
For both of these environments, it is possible to mount router to a switch board, the following there is no
need to have examination immunity or issues in connection with EMC according to EN 61439-1:2011.
Compliance of EN 61439-1:2011 specification, it is necessary to observe next assembly of the router
to the switch – board:
• For whip antennas, we recommend to observe a distance of 6 cm from cables and metal surfaces
on every side due to the elimination of interference. While using an external antenna except for the
switch-board it is necessary to fit a lightning conductor.
• Before mounting a router on sheet-steel we recommend using a cable antenna.
• For every cables we recommend to bind the bunch, we recommend for this use:
– Length of the bunch (the combination of power supply and data cables) can be maximum 1.5 m. If
the length of data cables exceeds 1.5 m or in the event of, the cable leads towards the switch –
board. We recommend installing over – voltage protectors (surge suppressors).
– With data cables they mustn't carry cables with reticular tension
• Sufficient space must be left before individual connectors for handling of cables,
• For correct function of the router we recommend to use in the switch-board earth-bonding distribution
frame for grounding of power supply of router, data cables and antenna.
SmartMotion ST352 Hardware Manual
Figure 9: Basic dimensions of the router box
3.5 Basic dimensions of the router box
230 V/50 Hz.
9