Table of Contents
Advertisement
DISASSEMBLY OPERATIONS (continued)
USER INTERFACE BOARD REMOVAL AND REPLACEMENT PROCEDURE
10. Using the torx T25 wrench remove the 4 screw (A) that are fixing the User Interface assembly on the Feeder front
panel. See Figure 2.
11. Pull carefully the User Interface board and disconnect the connector X100 from the User Interface.
12. Using the Torx T25 wrench remove the 4 screws (B) that are fixing the User Interface Board to the metal frame.
See Figure 2.
13. Remove the User Interface board from the feeder.
14. For the new User Interface Board re-assembly operations, make the previous steps in the reverse order
For LF52D
B
Figure 2
A
A
Advertisement
Table of Contents
