Lincoln Electric 50448 Service Manual page 23

Settings and Configuration Menu
To access the Settings and Configuration Menu:
Press the button [34] or right knob [33] to get access to
Welding Parameters Bar.
Use the right knob
"Configuration".
Press the right knob [33] to confirm the selection.
Figure 37
Table 12 Configuration Menu
Symbol
Limits
Display Configuration Settings
Brightness Level
Access control
Enable/ Disable Jobs Mode or Select
Jobs for Jobs Mode
Set the Language
Restore Factory Setting
Machine information
Advanced Setup
Cooler
Service Menu
Limits – it allows the operator to set the limits
of main welding parameters in selected job.
The Operator is able to adjust the parameter
value within specified limits.
WARNING
Limits can be set only for the programs stored in the user
memory.
[33] to highlight the
Description
Limits can be set for below parameters:
Welding Current
Wire Feed Speed
Welding Voltage
Hot Start
icon
Arc Force
Pinch
To set the range:
Enter to „Configuration" menu.
Use right knob [33] to highlight „Limits" icon.
Press right knob [33] to confirm. List with available jobs
will be shown on the screen.
Use right knob [33] to highlight the job.
Press right knob [33] to confirm selection.
Use right knob [33] to choose the parameter which will be
changed.
Press right knob [33] to confirm.
Use right knob [33] to change the value. Press right knob
[33] to confirm.
Figure 41 shown the effect of parameter values change.
Figure 38
Figure 39
Figure 40