Table of Contents
Advertisement
Wire Spool Type B300 Loading
WARNING
Turn the input power OFF at the welding power source
before installation or changing a wire spool.
Turn the input power OFF.
Open the spool wire case.
Unscrew the Locking Nut [16] and remove it from the
Spindle.
Place the adapter of spool type B300 on the spindle [17].
Make certain that the spindle brake pin is put in the
hole in the back side of the adapter. The adapter of
spool type B300 can be purchased separately (see
"Accessories" chapter).
Install the locking nut [16]. Make sure that the locking nut
is tightened
Rotate the spindle and adapter so the retaining adapter
spring of the adapter is at the 12 o'clock position.
Place the spool type Readi-Reel
of the spool wire inside in the groove of the locking
spring.
WARNING
Position the spool type B300 so that it will rotate in the
same direction as wire feed and electrode wire should
feed from the bottom side of the spool.
Wire Spool Type Readi-Reel® Loading
Turn the input power OFF.
Open the spool wire case.
Unscrew the Locking Nut [16] and remove it from the
Spindle.
Place the adapter of spool type Readi-Reel
spindle [17]. Make certain that the spindle brake pin is
put in the hole in the back side of the adapter. The
adapter of spool type Readi-Reel
separately (see "Accessories" chapter).
Install the locking nut [16]. Make sure that the locking nut
is tightened.
Rotate the spindle and adapter so the retaining spring of
the adapter is at the 12 o'clock position.
Place the spool type Readi-Reel
of the spool wire inside in the groove of the locking
spring.
WARNING
Position the spool type Readi-Reel
the same direction as wire feed and electrode wire should
feed from the bottom side of the spool.
®
on the adapter. Set one
®
on the
®
can be purchased
®
on the adapter. Set one
®
so that it will rotate in
Loading the Electrode Wire
Turn the input power OFF.
Open the spool wire case.
Unscrew the locking nut of the sleeve [16].
Load the spool wire on the sleeve such that the spool
turns clockwise when the wire is feed into the wire
feeder.
Make sure that the spindle brake pin goes into the fitting
hole on the spool.
Screw in the locking nut of the sleeve.
Open the wire drive door.
Put on the wire roll with the correct groove corresponding
to the wire diameter.
Free the end of the wire and cut off the bent end making
sure it has no burr.
WARNING
Sharp end of the wire can hurt.
Rotate the wire spool clockwise and thread the end of the
wire into the wire feeder as far as the Euro Socket.
Adjust force pressure roll of the wire feeder properly.
Adjustments of Brake Torque of Sleeve
To avoid spontaneous unrolling of the welding wire the
sleeve is fitted with a brake.
Adjustment is carried by rotation of its screw M10, which
is placed inside of the sleeve frame after unscrewing the
brake locking nut.
Figure 72
42. Locking Nut.
43. Adjusting Screw M10.
44. Pressing Spring.
Turning the M10 screw clockwise increases the spring
tension and increase the brake torque
Turning the M10 screw anticlockwise decreases the
spring tension and decrease the brake torque.
After finishing of adjustment, you should screw brake
locking nut again.
Advertisement
Table of Contents
