Lincoln Electric 50448 Service Manual page 27

Figure 57
Press right knob [33] to confirm the selection.
WARNING
After activated Job Mode the icon of this function will be
displayed on the Welding Parameters Bar. Load Memory
and Save Memory options will be blocked in this mode.
Set the Language – user can choose
interface language (English, Polish, Finnish,
French, German, Spanish, Italian, Dutch,
Romanian).
To set the language:
Access to the "Configuration" menu.
Use right knob [33] to highlight the "Set the Language"
icon.
Figure 58
Press the right knob [33]. The Language Menu is shown
on the display.
Figure 59
Use right knob [33] to choose the Language.
Press the right knob [33] to confirm selection.
Restore Factory Setting
WARNING
After Factory Settings restore, the settings stored in user
memory will be deleted.
To restore factory settings:
Access to "Configuration" menu.
Use right knob [33] to highlight the "Restore Factory
Settings' icon.
Figure 60
Press the right knob [33]. The "Restore Factory Settings"
icon is shown on the display.
Use the right knob [33] to highlight the "Check Mark".
Figure 61
Press right button [33] to confirm selection. The factory
•
settings are restored.
Machine information
Available information:
Software Version.
Hardware Version.
Welding Software.
Machine IP Address.
Advanced Setup
This menu enables access to the configuration
parameters of the device. To set the
configuration parameters:
Access to "Configuration" menu.
Use right knob [33] to highlight the "Advance setup" icon.