Table of Contents
Advertisement
1. Specifications
1-1 Specifications
Fluid
Proof pressure
Max. operating pressure
Min. operating pressure
Ambient and fluid
temperature
Lubrication
Stroke length tolerance
Cushion
Piston speed
Action
Use the actuator with allowable kinetic energy or less.
(Refer to 2-6. Allowable kinetic energy (Page 10))
！
W a r n i n g
Confirm the specifications.
The product is designed only for use in industrial compressed air systems. Do not operate at
pressures, temperatures or kinetic energy beyond the range of specifications, as this can cause
damage to cylinder or malfunction.
(Refer to the specifications.)
2. Installation and Handling
2-1. Air supply
The compressed air supplied to the cylinder should be filtered by SMC AF series air filter and
regulated to the specified set pressure by SMC AR series regulator.
！
W a r n i n g
Use clean air.
Do not use compressed air which contains chemicals, synthetic oils containing organic solvents,
salts or corrosive gases, etc., as this can cause cylinder damage or malfunction.
！
C a u t i o n
Install an air filter.
Install an air filter upstream near the valve. Select an air filter with a filtration size of 5μm or
smaller.
Therefore, take appropriate measures to ensure good air quality, such as
providing an after cooler, air dryer, or water separator.
Compressed air that contains a large amount of drainage can cause malfunction of pneumatic
equipment such as valves. Therefore, take appropriate measures to ensure air quality, such as
providing an after cooler, air dryer, or water separator.
Ensure that the fluid and ambient temperature are within the specified
range.
When operating at temperatures below 5
damage or malfunction. Measures should be taken to prevent freezing.
For the details of compressed air mentioned above, refer to SMC catalog "Compressed Air
Purification System".
Air
1.5MPa
1.0MPa
0.05MPa
-10 to +70
(No freezing)
Not required (non-lube)
to 1000st
t0 1500st
Rubber bumper/ Air cushion
φ20 to φ63
50 to 1000mm/sec
φ80､φ100
50 to 700mm/sec
Double acting
o
o
C. -10 to +60
C with built-in magnet
+1.4
mm
0
+1.4
mm
0
o
C, water in the circuit may freeze and cause seal
－4－
Advertisement
Table of Contents
