Consumable Parts - SMC Networks C G1 N-Z Series Operation Manual

3-2-4. Mounting of seals
1) Rod seal (Fig.8, ① )
Pay attention to the mounting direction of the seal.
Apply grease all over the seal and inner surface of the bushing as shown in Fig. 9. If it is
difficult to apply grease, for example to a small bore diameter, use a precision
screwdriver. Do not scratch any surface with the screwdriver.
2) Piston seal (Fig. 8, ② )
Mount with care not to twist the piston seal. Apply grease to the seal groove and outer
circumference by rubbing grease into them as shown in Fig. 10.
3) Tube gasket (Fig. 8, ④ )
Mount with care not to twist the tube gasket.
Fig. 9 Rod seal
！
C a u t i o n
Confirm that there is no problem with operation and air tightness after

assembly.

3-3. Consumable parts

3-3-1 Replacement parts
Seal kit number
Grease pack
(Accessory)
Contents of the
seal kit
Wear ring
Grease pack part number: GR-S-010(10g)
！
C a u t i o n
The seal is not delivered in sealed packaging for storage independently, so

it must be used within 1 year.
A little less than 1mm
Grease
ø20
CG1N20Z-PS
ø20
CM-020-07-301B
GR-S-020 (20g)
ø25
CG1N25Z-PS CG1N32Z-PS
GR-S-010(10g)
Rod seal
Piston seal
Tube gasket
Grease pack (10g)
1pc. of each
ø25
CM-025-07-302B CM-032-07-304B
－22－
Grease
Fig. 10 Piston seal
φ40
ø32
CG1N40Z-PS
φ40
ø32
C1A040-07-305B