How To Assemble The Kit; Figure 5. Steval-Pdetect1 Connected To Stwin.box - ST STEVAL-PDETECT1 User Manual

Presence detection evaluation board
Hide thumbs Also See for STEVAL-PDETECT1:
Table of Contents

Advertisement

To plug the flex cable onto the STWIN.box, remove the plastic case cover.
You can then remount the cover, as it leaves enough space for the flex cable.
The easiest way to read data from the
FP-SNS-DATALOG2
sensor data acquisition.
Note:
Be careful when you remove the flex cable as you may damage it. The safest way to remove it is by pulling it
next to the connectors using tweezers.
1.6.1

How to assemble the kit

ToF protective glass
The board is released with a protective tape on the ToF sensor. Before assembling the kit, take off this tape from
the sensor.
Then, remove the protective liner from the adhesive portion on the bottom of the cover glass.
UM3320 - Rev 1
Figure 5.
STEVAL-PDETECT1 connected to STWIN.box
STEVAL-PDETECT1
function pack. The firmware package provides a ready to use, precompiled binary to perform
sensors is by programming the STWIN.box with the
UM3320
Getting started
page 5/22

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STEVAL-PDETECT1 and is the answer not in the manual?

This manual is also suitable for:

Sths34pf80Vl53l8cxVd6283tx

Table of Contents