Advertisement
Quick Links
Quick guide for commissioning of swing gates
DAAB CONTROL UNIT EP104 V4.07
The unit may only be connected by a qualified electrician, who accepts
!
responsibility for ensuring that the electric connections have been carried out
in accordance with the applicable standards and this instruction manual. Always
disconnect the power supply when work is carried out in the control cabinet.
Anyone commissioning the EP104 must have documented familiarity with
and understanding of its functions, as well as experience of
commissioning control systems for the application to be used.
For complete instructions refer to instruction manual for EP104
as well as other documentation included in the delivery
BOX 125, SE-284 22 PERSTORP SWEDEN,
FAAC Nordic AB
+46 435 77 95 00,
support@faac.se
www.faac.se
Advertisement
Related Manuals for FAAC DAAB EP104 V4.07
Summary of Contents for FAAC DAAB EP104 V4.07
- Page 1 For complete instructions refer to instruction manual for EP104 as well as other documentation included in the delivery FAAC Nordic AB BOX 125, SE-284 22 PERSTORP SWEDEN, +46 435 77 95 00, support@faac.se...
- Page 2 QUICK GUIDE DAAB CONTROL UNIT EP104 V4.07 Quick guide for commissioning of swing gates • Prerequisites The electrical installation is complete and drive units should be disengaged from the drive arm. Operate only one drive unit at a time and start with drive unit 1. The type of motor power in C202 is set to 0, 3x400V with neutral. Limit switches must be of encoder type.
- Page 3 QUICK GUIDE DAAB CONTROL UNIT EP104 V4.07 • Comissioning of drive unit 2 Preparation: Open gate leaf 1 and set L001 to 0 to maintain the gate leaf in open position. Set C033 to 5, Service mode. Direction of movement: Set L002 to 4, hold-to-run without limit switches. Check that the drive arm mounting is moving in the right direction while pressing OPEN or CLOSE button on the controll board.
Need help?
Do you have a question about the DAAB EP104 V4.07 and is the answer not in the manual?
Questions and answers