FAAC E124 Rapid Manual

• Important! For the safety of people, it is important that all the instructions be carefully observed.
• Incorrect installation or incorrect use of the product could cause serious harm to people.
• Carefully read the instructions before beginning to install the product and keep them for future reference.
•
The symbol indicates notes that are important for the safety of persons and for the good condition of the automated system.
• The symbol draws your attention to the notes on the characteristics and operation of the product.
• Before attempting any work on the control unit (connections, maintenance), always turn off power.
• Install, upstream of the system, a differential thermal breaker with adequate tripping threshold,
• Connect the earth cable to the relevant terminal (see fig.5).
• Always separate power cables from control and safety cables (push-button, receiver, photocells, etc.). To avoid any electrical disturbance, use separate
sheaths or a screened cable (with the screen earthed).
Manufacturer: FAAC S.p.A.
Address: Via Benini,  - 40069 Zola Predosa BOLOGNA - ITALY
Declares that: The E24 control unit
• ·conforms to the essential safety requirements of the following EEC directives
2006/95/EC Low Voltage Directive
2004/108/EC Electromagnetic Compatibility Directive
Additional note:
Bologna, 01 March 2008
4 TECHNICAL SPECIFICATIONS
Primary power feed
from mains
Secondary power
feed
Power absorbed
from mains
Max. load
for motor
Power feed
for accessories
Accessories
max. current
Battery charge
current
Operating ambient
tempeature
Protective fuses
Function logics
"step-by-step" Semiautomatic, Automatic
with reverse during pause, Automatic
step-by-step, Safety devices automatic,
Safety devices step-by-step automatic,
"b" Semiautomatic, mixed logic "bC",
Dead-man, Automatic with timer function
Work time
Programmable (from 0 to 4 minutes)
Pause time
Programmable (from 0 to 4 minutes)
Motor power
Motor speed
E124 control unit – rapid guide

CE DECLARATION OF CONFORMITY

This product underwent tests in a typical uniform configuration
(all products manufactured by FAAC S.p.A.).
with switching power feed
230/5 V~ - 50/60 Hz
24 Vdc - 6 A max.
(min. 20 Vdc. - max. 28 Vdc.)
stand-by = 4W
max. ~ 400 W
7 A
24 Vdc
24Vdc max. 500 mA
BUS-2EASY max. 500 mA
80 mA
(-20 - +55) °C
All self resetting
Semiautomatic, Automatic,
Programmable on 50 levels
Programmable on 0 levels
WARNINGS
The Managing Director
A.Marcellan
Connector inputs
Terminal board inputs
Terminal board outputs
Programming
These instructions are to be considered
as a rapid guide for installation. The complete
instructions can be downloaded at the following
address: www.faacgroup.it
To access PROGRAMMING FROM PC, use the
X-COM module or connect the USB cable to the
dedicated connector and consult the dedicated
instructions.

Switching feeder, Battery,
Decoder/Minidec/RP , X-COM, module
XF433/868, USB
BUS-2EASY, Inputs from IN to IN5 (see
par. 5), Travel limit device, Encoder.
Flashing lamp, Motors, Electrical lock,
OUT, OUT2 (programmable), power feed
to accessories
st and 2° lev. with 3 keys (+, -, F) and LCD
display.
3rd lev. with P .C. connected via USB or with
X-COM module.