Time Stamp - Grandstream Networks GWN76 Series User Manual

Roaming Consortium
Roaming Consortium
Name
Domain
Domain
Realm
Realm
Cellular Network
Information
Cellular Network
Information
Port Configuration
IP Protocol
Port Number
Port Status
Terms and Condition
Filename
Timestamp
Advice of Charge
Type
Realm
Language Code
Currency Code
XML Content
Advanced
WAN Link Status
WAN Downlink Speed
WAN Uplink Speed
GAS Fragmentation Limit
GAS Comeback Delay
Disable Downstream
Group-Addressed
Forwarding
SNMP
This section lists the SNMP options available to integrate the GWN76xx with monitoring systems.
Configure the Roaming Consortium Name to identify network operators. The format is H-H-H
or H-H-H-H-H, where H is a 2-digit hexadecimal number.
Enter the domain name.
Select the EAP Method: EAP-TLS, EAP-SIM, EAP-TTLS, EAP-AKA and EAP-AKA'.
Enter the Name, Country Code and Network Code.
Configure the protocol type: ICMP, TCP, UDP or ESP.
Set the protocol port.
Set the port status to either: Open, Close or Unknown.
Specify the filename.
Select the timestamp
Select the type:
• Time-based
• Data-volume-based
• Time-and-data-volume-based
• Unlimited
Select the Realm.
Select the language code.
Select the currency: XSU, BTN, INR, CNY, MOP, HKD, XAF.
Upload XML file
Set the WAN Link Status to either: Not configured, Link-up, Link-down or Link-test.
Set Download speed.
Set Upload speed.
Set GAS fragmentation limit. Default is 1400.
Set GAS comeback delay. Default is 0.
When this option is disabled, it means the DGAF is enabled, the AP will forward all downlink
broadcast ARP messages and wireless group broadcasts.
When this option is enabled, the DGAF function is disabled, the AP will discard all downlink
broadcast ARP messages and wireless group broadcasts.
Disable DGAF function to prevent attackers from using the vulnerability of all clients in the
same BSS using the same Group Temporal Key (GTK) to forge Group address frames and then
attack the clients.
Hotspot 2.0