Jacking Vehicle; Servicing Air Cleaner - Toro Workman 3100 Operator's Manual

3. Push bed support onto cylinder rod, making sure
support end tabs rest on end of cylinder barrel and on
cylinder rod end (Fig. 28).
1
2
Figure 28
1. Bed support
2. Cylinder barrel
4. To store bed support, remove bed support from cylinder
and insert into brackets on back of ROPS.
5. Always install or remove bed support from outside of
bed.
6. Do not try to lower bed with bed safety support on
cylinder.

Jacking Vehicle

Danger
A vehicle on a jack may be unstable and slip off of
the jack, injuring anyone beneath it.
Do not start the vehicle while the vehicle is on a
jack.
Always remove the key from the switch before
getting off of the vehicle.
Block the tires when the vehicle is on a jack.
1. Do not start engine while vehicle is on jack, because
engine vibration or wheel movement could cause
vehicle to slip off jack.
2. Do not work under vehicle without jack stands
supporting it. The vehicle could slip off jack, injuring
any one beneath it.
3
3. Bed
36
3. The jacking point at the front of the vehicle is under the
front center frame support and at the rear it is under the
axle tube.
4. When jacking up front of vehicle, always place a 2x4
block (or similar material) between jack and vehicle
frame.
1
Figure 29
1. Front jacking point
1
Figure 30
1. Rear jacking points

Servicing Air Cleaner

The foam pre–cleaner must be cleaned and re–oiled after
every 25 hours engine operation if engine is operated in
clean air conditions. However, air cleaner must be cleaned
every few hours if operating conditions are extremely dusty
or sandy.
1. Remove knob, O–ring and cover.
2. Remove foam pre–cleaner by sliding it off the paper
element.
Wash foam pre–cleaner in detergent and warm
water.
Wrap foam pre–cleaner in cloth and squeeze dry. Do
not wring precleaner. Allow to air dry.
Saturate foam pre–cleaner in engine oil. Squeeze to
remove excess oil.
3. Reinstall on paper cartridge.
1