Table of Contents
Advertisement
hosts" file and may deny access to the controller unless the
file is updated with the new key.
Configure the XstreamCORE
Use the Command Line Interface (CLI) to configure or view
current settings for the XstreamCORE. This is accessible
through an SSH terminal client. Default values are
appropriate for most configurations, but may be modified.
Help is available from within the CLI by using help followed by
the command name. For more information on any of these
parameters, refer to the specific CLI command in
explanations.
Preliminary steps
Connect to the Management Port's IP address of your
XstreamCORE from an SSH client and type in your user
name and password when prompted.
The CLI splash appears. Check default settings in Info to
ensure they are appropriate for your configuration. Use
the commands pointed to by the Help command to verify
and change settings.
Exhibit 2 XstreamCORE 8100T SSH Splash Screen
Port configurations
Follow the
If using IPv4 DHCP to assign Ethernet port addresses then
use set IPDHCP to enable DHCP for the selected Ethernet
port(s).
suggested the DHCP server reserve an IP address for the port's
MAC address to avoid having the device's IP migrating, possibly
losing CLI access.
If using IPv6 DHCP to assign Ethernet port addresses use
Command
set IPV6DHCP to enable DHCP for the selected Ethernet
port(s).
If using static IPv4 addresses then use set IPAddress, set
IPSubnetMask, set IPGateway on the selected Ethernet
port.
If using static IPv6 addresses then use set IPV6Address,
set IPV6Prefix, set IPV6Gateway on the selected
Ethernet port.
Modify passwords
Follow the
Use the Password command to begin an interactive
command session
Enter appropriate information when prompted to enter
the current password, then the new password.
If the password has been lost, the XstreamCORE 8100T can be
defaulted using the reset button. Holding the reset button
for 5 seconds will reset all configurations to default, including
the password.
Exhibit 3 - Setting the Password
Preliminary
steps.
If using DHCP on the management port, it is
Preliminary
steps.
Advertisement
Table of Contents
