Table of Contents
Advertisement
Manual mapping mode
To change mapping mode to manual mode, perform the
following:
Run the set iSCSIMappingMode Manual command while
there are no initiators logged in. This will delete all
target nodes on the device. A reboot is required.
Target nodes will need to be created using the
iSCSITargetCreate command, specifying the name of the
target and which data ports the target is accessible from.
Up to four iSCSI targets may be created.
Exhibit 5 - Configure Manual iSCSI Mapping Mode
New LUNs can be added to the target by using the
iSCSIMap command. This command uses the target
name (or the target ID as displayed in the
iSCSIShowMaps) along with the device ID (as seen in
ShowDevices) and the desired LUN. The LUN typically
starts at zero and increments for each iSCSI target.
Some host operating systems may require a device
at LUN 0 on each iSCSI target.
Advertisement
Table of Contents
