Table of Contents
Advertisement
LTFS Partition (Tape devices only)
Some manufacturers' drivers use non-standard
names for tape devices.
To create an LTFS partition, enter the following command:
mkltfs /dev/IBMtapeX
stX is the tape device to create a partition on.
To mount an LTFS partition, enter the following command:
ltfs /path/to/mount -o devname=/dev/IBMtapetX
/path/to/mount is the desired directory in which to
mount the partition. stX is the tape device where the LTFS
partition resides.
Disconnect from the Target
To log out from a target, enter the following command:
iscsiadm -m node -T target -p ipaddress -u
target must match the full target name returned
from the discovery command above. ipaddress is the address of
the XstreamCORE data port used in the discovery command
above.
You can connect/disconnect to/from all discovered
targets by omitting the -T target parameter from the log in/out
commands
Advertisement
Table of Contents
