Table of Contents
Advertisement
until a response and possibly data has been transmitted back
to the initiator.
Queue time is how long a command that's ready has waited
before being submitted to the device. Applies to writes only.
Device time represents how long the SAS device took to
complete a command.
Response to Command time is the time between transmitting
a response for one command and beginning iSCSI processing
of the next. Includes host delay.
R2Ts are the number of Ready to Transfer messages that were
needed to fetch all data for a write command. Applies to
writes only.
iSCSILatency
iSCSILogins (Immediate)
Displays details of the initiators currently logged in (active),
and optionally of initiators previously logged in as well
(inactive). Displays active logins by default and both active
and inactive if the 'all' argument is specified.
iSCSILogins <all>
iSCSIMap (Immediate)
Manual mapping mode only. Map a device to an iSCSI target.
Use CLI commands iSCSIShowMaps and ShowDevices to see
the target and device IDs.
iSCSIMap [Target ID | name] [Device ID] [LUN]
iSCSIMappingMode
Changes the iSCSI mapping mode. In automatic mode devices
are assigned to predefined iSCSI targets based on SAS
topology. iSCSI targets are only accessible when devices are
attached. Manual mode allows user creation and deletion of
iSCSI targets and user mapping of devices to targets.
Changing the mapping mode may require a reboot before
taking effect.
set iSCSIMappingMode [automatic | manual]
get iSCSIMappingMode
iSCSISetPorts (Immediate)
Configure the iSCSI target data port accessibility.
iSCSISetPorts [Target ID | name] [DP1 | DP2 | all | none]
iSCSIShowMaps (Immediate)
Display mapping details between iSCSI targets and devices.
iSCSIShowMaps
iSCSITargetCreate (Immediate)
Manual mapping mode only. Create an iSCSI target. The
target name is formatted as follows:
iqn.yyyy-mm.<naming authority>:<unit serial number>.<IQN
suffix>
The provided IQN suffix must be between 1-32 characters.
iSCSITargetCreate [IQN suffix] [DP1 | DP2 | all | none]
iSCSITargetDelete (Immediate)
Manual mapping mode only. Delete an iSCSI target.
iSCSITargetDelete [Target ID | name]
iSCSIUnMap (Immediate)
Manual mapping mode only. Remove a mapping between
device and iSCSI target. Use CLI commands iSCSIShowMaps
and ShowDevices to see the target and device IDs.
iSCSIUnMap [Device ID]
Licenses (Immediate)
Displays the collection of relevant open source licenses used
by the unit.
Licenses
Advertisement
Table of Contents
