Table of Contents
Advertisement
Help (Immediate)
The Help command issued with no parameters displays a list
of available CLI commands. When a CLI Command name is
specified, a command usage string and command description
is presented on the CLI.
Help <command>
Info (Immediate)
Displays version number and other system information for key
components of the unit.
Info
IPAddress
Configures the current IP address of any Ethernet port(s).
If IPDHCP is enabled, the 'get' command reports the current
IP address assigned by the network DHCP server, followed by
the (DHCP) identifier.
set IPAddress [DP[n] | MP[n]] [xxx.xxx.xxx.xxx]
get IPAddress [DP[n] | MP[n] | all]
IPDHCP
Configures the current DHCP setting. DHCP allows acquisition
of an IP address from a network DHCP server. When this
option is disabled, the IP address used is specified by the
"IPAddress" command.
set IPDHCP [DP[n] | MP[n] | all] [enabled | disabled]
get IPDHCP [DP[n] | MP[n] | all]
Iperf3Server
Enable or disable an iperf3 server to aid network
configuration and troubleshooting.
set Iperf3Server [enabled | disabled]
get Iperf3Server
IPGateway
Configures the current default gateway used by the specified
Ethernet port.
set IPGateway [DP[n] | MP[n] | all] [IP Address]
get IPGateway [DP[n] | MP[n] | all]
IPSubnetMask
Configures the current subnet masks used by the specified
Ethernet port.
set IPSubnetMask [DP[n] | MP[n] | all] [xxx.xxx.xxx.xxx]
get IPSubnetMask [DP[n] | MP[n] | all]
IPV6Address
Configures the current IPv6 address of any Ethernet port(s).
If IPV6DHCP is enabled, the 'get' command reports the current
IP address assigned by the network DHCP server, followed by
the (DHCP) identifier.
set IPV6Address [DP[n] | MP[n]] [IPv6 Address] | [IPv6
Address/Prefix]
get IPV6Address [DP[n] | MP[n] | all]
IPV6DHCP
Configures the current DHCPv6 setting. DHCP allows
acquisition of an IP address from a network DHCP server.
When this option is disabled, the IP address used is specified
by the "IPV6Address" command.
set IPV6DHCP [DP[n] | MP[n] | all] [enabled | disabled]
get IPV6DHCP [DP[n] | MP[n] | all]
IPV6Gateway
Configures the current default gateway used by the specified
Ethernet port.
set IPV6Gateway [DP[n] | MP[n] | all] [IP Address]
get IPV6Gateway [DP[n] | MP[n] | all]
IPV6Prefix
IPV6Prefix controls the current IPv6 prefix of any Ethernet
port(s).
set IPV6Prefix [DP[n] | MP[n]] [Prefix length]
get IPV6Prefix [DP[n] | MP[n] | all]
iSCSIChangeTargetSuffix (Immediate)
Automatic mapping mode only. Change the default iSCSI
qualified name (IQN) suffix. The changeable suffix begins
following the serial number in the IQN formatted as follows:
Advertisement
Table of Contents
