Table of Contents
Advertisement
Password
Specifies the password used for all interactive sessions that
require a login. Password is case sensitive, 8 to 32 characters,
must contain at least one numeric character {0-9} and cannot
contain the following special characters: {space, tab, ", ', \, ;}.
set Password
Ping (Immediate)
Ping will send an ICMP echo request to the specified host via
the specified network interface.
Ping [DP[n] | MP[n]] [IP Address] <count <size>>
RestoreConfiguration (Immediate)
Restores the configuration back to defaults. Use the default
option to revert the SSH/SFTP admin password back to the
original password. All Ethernet configuration settings and
iSCSI maps are also reset to defaults. The default option is
equivalent to pressing and holding the reset button for 5
seconds to restore settings. The unit will reboot as part of the
process. The factory option reverts the file system and should
not normally be used unless under direction by ATTO
customer support.
NOTE: the factory option may take up to 15 minutes to
complete.
RestoreConfiguration <default | factory>
SASConnectorStats (Immediate)
Displays SAS PHY error statistics. The argument "verbose"
will print out the legend for the header values.
SASConnectorStats <verbose>
SASPortList (Immediate)
Displays SAS PHY link information.
SASPortList
SendEOMDeferredError
End Of Medium (EOM) deferred error configuration controls
early warning deferred errors generated by SpeedWrite.
Enable this setting if there are issues with end of tape
handling.
set SendEOMDeferredError [enabled | disabled]
get SendEOMDeferredError
SFPInfo
SFPInfo displays information about the specified SFP(s).
get SFPInfo [DP1 | DP2 | all]
ShowDevices (Immediate)
Display SAS device details.
ShowDevices
Temperature
Displays the current operating temperatures of the various
temperature sensors in degrees Celsius.
get Temperature
Timesync
Configures the "timesync" service. Timesync automatically
adjusts the system date and time based on well-known time
servers.
set Timesync [enabled | disabled]
get Timesync
TimesyncServer
Sets/displays timesync servers.
Assign up to three timesync servers separated by spaces or
use 'delete' to remove all.
set TimesyncServer [List of up to 3 timesync servers | delete]
get TimesyncServer
Advertisement
Table of Contents
