Table of Contents
Advertisement
12 4
14
9 14
26
Step 3
It is recommended to have a second person assist with this step. One person should hold
the Handlebar Bracket (9) with Computer Console (18) in place while the other person
connects the wires.
Connect the Control Cable (16) from the Right Handlebar Support Tube (27) to the wire
that comes from the Computer Console (18).
Attach the Handlebar Bracket (9) with Computer Console (18) onto the both Left/Right
Handlebar Support Tubes (14, 27) with two Hexagon Socket Button Head Bolts (4), two
Curve Washers (12), two Hexagon Socket Button Head Bolts (15), and two Nylon Nuts
(26). Tighten bolts and nylon nut with the Allen Wrench and Multi Hex Tool with Phillips
Screwdriver provided.
IMPORTANT: While attaching the Handlebar Bracket (9) with Computer Console (18) onto
the both Left/Right Handlebar Support Tubes (14, 27), make sure the wires are installed
inside the Right Handlebar Support Tube (27) and pay attention not to pinch the wires.
NOTE: PLEASE FULLY TIGHTEN BOLTS INSTALLED IN STEP 2 WITH THE ALLEN
WRENCH PROVIDED.
Hardware:
(4) Hexagon Socket
Button Head Bolt
2 PCS
9
9
4
12
26
15
(12) Curve Washer
2 PCS
16
4
12
15
15
14
(15) Hexagon Socket
Button Head Bolt
2 PCS
11
18
26
27
18
16
27
(26) Nylon Nut
2 PCS
Advertisement
Table of Contents
