Filament - FLASHFORGE 3D PRINTER Adventurer 3 Pro 2 User Manual

2.3.3 Filament

Load
Change
Manual
Load
The extruder is heated up to the target temperature.
After heat completed, insert the filament into the extruder at an upright angle until
some resistance is sensed [as the filament is pushed through the feeding wheel].
Load will complete when you see filament come out of extruder.
Load
Change
Manual
Change
The extruder is heated up to the target temperature, after heat completed, filament
will be unloaded from the extruder.
Pull out the filament according to the instruction.
Insert new filament into the filament intake, tap [OK] ;
New filament will be pushed into the extruder, replace will complete when you see
new filament come out of extruder.
Load
Change
Manual
240
/265℃
Heating extruder...
Cancel
265
/265℃
Unloading the filament,
please wait...
100 mm
200 mm
300 mm
Load
265
/265℃
Preheat completed.
Begin loading.
OK
265
/265℃
Pull out filament,
feed new filament, press [OK]
OK
Manual operate
Wait until the extruder is heated up to
the target temperature, choose the
loading length, click on [Loading];
Load the filaments, make a push until
the resistance is felt;
Gear set works. Filaments coming out
of the extruder in dicates a success.
22
265
/265℃
Press OK when new color appears
OK
265
/265℃
Please insert the filament
OK