Table of Contents
Advertisement
Power Switch
Status
Language
Calibration
Homing
1/3
6. Click [Tools]-[Setting] in turn to enter page like this, turn to page two, click [Move].
Click the upper arrow in the moving page to make the extruder raises for removing
the paper box on the bottom easier.
5. Plug the power cable into the input on
the back and turn on the power switch,
the touch screen is turned on.
Move
Camera
Filament Check
Led
2/3
7. Open the front door, take out the paper box
inside the printer, the printer unpacking
completed.
09
X: 20.00 Y: 45.00 Z: 36.00
Y
x
z
Advertisement
Table of Contents
Need help?
Do you have a question about the Adventurer 3 Pro 2 and is the answer not in the manual?
Questions and answers