Kenwood DP-3010 Service Manual page 5

DP-3010 DP-3010
DISASSEMBLY FOR REPAIR DISASSEMBLY FOR REPAIR
SINGAPORE MADE SINGAPORE MADE
1—2. Installing the Tray
1. Set the gear to the position (@) shown in the diagram,
2. Insert the tray along with the guide rails on the both
sides.
1. Removing and Installing the Tray
1—1, Removing the Tray
* Qpen the disc tray and turn the power OFF.
1. Push the tray gradually into the unit (@) by your
hand. In this condition, the gear will be released (@).
2. Push the rear end of the tray toward the front to remove
the tray until it stops 3) ).
3. Remove the two screws (d) of the tray stopper.
4. Draw out the tray (@).
Lal
ra} Q
x <r
Ss —
Lad
ad oc
Oo [om]
a Qa.
4 <x
=) rao}
= =
77) w 2. Installing the Loading Gear
2-1. Installing the Drive Gear
Align the drive gear with the cutout section of the
control cam to install it.
Note : When the power can not be turned ON, or when
the tray can not be opened by pressing the OPEN key :
1) Rotate the contro) cam by a screwdriver, etc. set into
the hole on the bottom plate of the unit as shown (@).
2) When the tray is comes out slightly, the gear is released.
Then take out the tray toward the front '@ ).