Kenwood DP-3010 Service Manual page 3

JAPAN MADE
DP-3010
DISASSEMBLY FOR REPAIR
JAPAN MADE
1. Removing the Control Unit
*" Remove the case beforehand. There is no need to
remove the stand-offs or holder
1) Remove the tray panel by stiding it upward C1)
2) Push tray in the airection of @
3) Remove the three screws @, unlatch the four hooks
OQ and remove :ne front panel @.
4) Remove the two screws @ and the headphone
board screw Q 79 remove the sub-panel (3)
DISASSEMBLY FOR REPAIR
DP-3010
JAPAN MADE
19)
5) Remove the three screws @. unlatch the seven
hooks (10) and remove the control unit ®
2. Removing the Tray
li First open the tray and switch power off
2) Slowly push the tray inwards @* There will be a
point where the gear will be at a pe:nt where it will be
free
3) Push the tray toward yourself while oushing outward
from the back
4) Unlatch the two stopper hooks @
Lid
o|
ca
=
=
a at
-