Kenwood DP-3010 Service Manual page 4

DP-3010 DP-3010
DISASSEMBLY FOR REPAIR DISASSEMBLY FOR REPAIR
JAPAN MADE JAPAN MADE
5} When removing the tray, the stopper hooks will latch 4. Removing the Pick-up
onto the sub-unit. Remove by iting the tray upward * Remove tray beforehand
asin @ 1) Remove the two screws @ and take off the metal
clamp.
Lid
r=
<=
=
a.
4
or)
JAPAN MADE
2-1. When there is no power, or the tray does not
come out even if OPEN is pressed.
1) Insert a screw driver througn the slit in the bottom
plate and push the lever forwaa @
2) The tray will move forward a: itle and the gear will be
freed so the tray can be pullec 2ut 6
2) Remove the gear after taking off the ring stopper @
3) Romove the two clamps
4) Remove the Pick-up as shown in the diagram a)
Note 1} Replacement of the Pick-up
* Make sure that clamp and the guide of the Pick-up
meet A.
* Keep the two cords coming out of the Pick-up as far
away from eachother as possible B .
Note 2} When changing the Pick-up
* To protect the Laser Diode (LD) of the service part
Pick-up (J91-0385-08), the LD shortland C_ is
shorted with solder. When changing this part,
remove the solder only after the connector has
been connected.
3. Replacing the tray
1) Move the gear into the same g:sitionas A
2) Push the tray in on the guides =" both sides of the slot.
3) Turn on the power and switch 'AD Assy to UP
4) Push the tray OPEN/CLOSE KEY to confirm normal
movement.