Otto Bock 8E70 Series Instructions For Use Manual page 14

3.5 Information on Proximity to Certain Areas
CAUTION
Insufficient distance to HF communication devices (e.g. mobile phones, Bluetooth
devices, WiFi devices)
Injury due to unexpected behaviour of the product caused by interference with internal data
communication.
Therefore, keeping a minimum distance of 30 cm from HF communication devices is recom­
►
mended.
CAUTION
Operating the product in very close proximity to other electronic devices
Injury due to unexpected behaviour of the product caused by interference with internal data
communication.
Do not operate the product in the immediate vicinity of other electronic devices.
►
Do not stack the product with other electronic devices during operation.
►
If simultaneous operation cannot be avoided, monitor the product and verify proper use in
►
the existing setup.
CAUTION
Proximity to sources of strong magnetic or electrical interference (e.g. theft prevention
systems, metal detectors)
Injury due to unexpected behaviour of the product caused by interference with internal data
communication.
Avoid remaining in the vicinity of visible or concealed theft prevention systems at the
►
entrance/exit of stores, metal detectors/body scanners for persons (e.g. in airports) or other
sources of strong magnetic and electrical interference (e.g. high-voltage lines, transmitters,
transformer stations, computer tomographs, magnetic resonance tomographs, etc.).
When walking through theft prevention systems, body scanners or metal detectors, watch
►
for unexpected behaviour of the product.
3.6 Information on Use
CAUTION
Mechanical stress on the product
Injury due to faulty control or malfunction of the product.
Do not subject the product to mechanical vibrations or impacts.
►
Check the product for visible damage before each use.
►
CAUTION
Improper use
Injury due to faulty operation or malfunction of the product.
Instruct the patient in the proper use of the product.
►
CAUTION
Improper product care
> Injuries due to faulty control/malfunction of the product or damage to the mechanical com­
ponents
14