Table of Contents
Advertisement
2 | Advanced Adjustments/Settings
• High
Turns the backlight off. This provides the highest power saving effect.
• Low
Sets the backlight to the lowest lighting level. The time until operation stabilizes after
restoring from power saving mode can be reduced.
• Off
Does not enable the power saving mode. The backlight lights up irrespective of the PC
status. This setting may shorten the backlight life.
Note
• When not using the monitor, you can turn off the main power supply or disconnect the power
plug so that the power is cut completely.
• Devices connected to the USB upstream port and downstream port still work when the monitor is
in the power saving mode or when the power is switched off using the power button (
monitor. For this reason, power consumption of the monitor varies with connected devices even
in the power saving mode.
• When the signal input from the PC is no longer detected, a message appears notifying the user
of the transition to power saving mode. The monitor enters power saving mode five seconds after
the message appears.
• When power save is set to "High" or "Low", the status of the monitor can be confirmed by
checking the color of the indicator on the power switch.
– Power indicator is green: Monitor is in normal operation mode
– Power indicator is orange: Monitor is in power saving mode
Indicator
Settings: "1" – "7" / "Off"
The brightness of the power switch indicator (green) while the screen is displayed can be
adjusted. The larger the set value, the brighter the power indicator lights up. On the other
hand, the smaller the value, the darker it becomes. The "Off" setting turns off the power
switch indicator.
USB Selection
Settings: "USB 1" / "USB-C" / "USB 1 - USB 2" / "USB 1 - USB-C"
You can select the PC that controls the USB peripherals such as a mouse and keyboard
connected to the USB downstream port of the monitor.
• "USB 1"
The PC connected to USB-B 1 (
• "USB-C"
The PC connected to USB-C (upstream:
• "USB 1 - USB 2"
Set to manually switch whether the PC connected to USB-B 1 (
to USB-B 2 (
) uses the USB peripheral device. If this is set ,
operation guide. Touch the displayed operation switch (
2".
• "USB 1 - USB-C"
Set to manually switch whether the PC connected to USB-B 1 (
to USB-C (upstream:
displayed in the operation guide. Touch the displayed operation switch (
"USB 1" or "USB-C".
16
) is selected.
) is selected.
) uses the USB peripheral device. If this is set ,
) of the
) or the PC connected
is displayed in the
) and select "USB 1" or "USB
) or the PC connected
is
) and select
Advertisement
Table of Contents
