5-4. Setting the Signal Format of DisplayPort 1
You can specify the DisplayPort 1 version, and enable or disable daisy-chain connection.
●
Switching the DisplayPort 1 version
Attention
• When a PC is connected via the DisplayPort 1 connector, the DisplayPort version may differ depending on
the PC, and consequently the screen may not appear. In this case, try changing the following settings.
Procedure
1. Select
to turn off the monitor.
2. While touching the leftmost switch (
monitor.
3. Select "Signal Format" from "Administrator Settings", then select
4. Select "DisplayPort 1", then
5. Select "Version", then
6. Select "1.1" or "1.2" using
7. Press
twice.
The "Administrator Settings" menu appears.
8. Select "Apply", and then select
●
Enabling or disabling daisy-chain connection
Enable or disable daisy-chain connection. Setting this option to "On" enables a signal to be output
from the DisplayPort output terminal to another monitor or DisplayPort 2.
Attention
• To enable daisy-chain connection, select "DisplayPort 1" and set "Version" to "1.2".
• Visit the EIZO website for information about monitors and graphic boards that can be used for the daisy-
chain connection:
http://www.eizoglobal.com
Procedure
1. Select
to turn off the monitor.
2. While touching the leftmost switch (
monitor.
3. Select "Signal Format" from "Administrator Settings", then select
4. Select "DisplayPort 1", then
5. Select "Daisy Chain", then
6. Select "On" or "Off" using
7. Press
twice.
The "Administrator Settings" menu appears.
8. Select "Apply", and then select
26
Chapter 5 Configuring Monitor Settings
), touch
.
.
or
, then select
.
), touch
.
.
or
, then select
.
for more than two seconds to turn on the
.
.
for more than two seconds to turn on the
.
.