Pioneer SX-P830 Operating Instructions Manual page 73

Stereo receiver, stereo double cassette deck, sound field processor, sound image controller, speaker system
Table of Contents

Advertisement

TROUBLESHOOTING
No power is sup-
plied, even when
power switch is
turned on.
*
Power plug is disconnected from wall
socket.
*
Connection cables are not connected
correctly.
Connect the plug correctly.
¢
Consult the preparation and connection
sections of your operating instructions
and connect correctly.
e
Consult the preparation and connection
disconnected from their terminals.
sections of your operating instructions
and connect correctly.
e
Set to the music source you wish to
hear.
e
The receiver's function is not set
properly.
CASSETTE TAPE
The cassette door
doesn't open.
¢
Power was turned off while tape was
¢
Turn on power again, then press the
running.
eject button { &).
prevention tab has been broken out.
e
Either replace the tape cassette, or
place a piece of cellophane tape over
the tab hole.
The sound is
muddy.
When rerecording
over a previously
recorded tape, the
sound of the previ-
ous recording re-
mains audible.
¢
Heads are dirty.
Clean the heads.
Sound is muddy,
high-frequency
sounds are too
strong.
*
The DOLBY
NR switch is set at a posi-
tion different from that used during
recording.
e
Try changing the position of the DOL-
BY NR switch.
You are using a tape without minimum
4-second nonrecorded intervals be-
tween tracks.
The music search
(MS) function
doesn't work.
Use a tape with silent intervals of at
least 4 seconds between tracks.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet as
this could cause a short circuit or electric shock. Do not place the unit,
a piece of furniture, etc., on the power cord, or pinch the cord. Never
make a knot in the cord or tie it with other cords. The power cords
should be routed such that they are not likely to be stepped on. A
damaged power. cord can cause fire or give you an electrical shock.
Check the power cord once in a while. When you find it damaged, ask
your nearest PIONEER authorized service center or your dealer for a
replacement.
73
<ARE1252>
En

Advertisement

Table of Contents
loading

Table of Contents