G.703 Dte Loopback - Paradyne 7974 User Manual

G.703 DTE Loopback

"
7900-A2-GB21-00
G.703 DTE Loopback loops the G.703 signal back to itself before the signal is
sent to the Framer.
Activating the G.703 DTE loopback test causes the EOC, used for management,
to be lost to the remote unit.
CAP
DSL
All Ones
Port
Transceiver
Procedure
To run a G.703 DTE Loopback:
1. Position the cursor at the Start command next to G.703 DTE Loopback on
the Network & G.703 Tests screen.
2. Press Enter.
The Start command is changed to Stop.
3. To manually stop the test, verify that the cursor is positioned at the Stop
command and press Enter.
A G.703 DTE loopback cannot be started when any other loopback test is in
progress.
August 2000
CAP E1
LIU
Framer Framer
Testing
G.703
Port
98-16000
8-15