Paradyne 7974 User Manual page 69

Entry Response Messages
7900-A2-GB21-00
The messages in Table 7-4, listed in alphabetical order, can appear in the
messages area at the bottom of ATI screens in response to commands or data
entry.
Table 7-4. Entry Response Messages (1 of 2)
Device Message What Message Indicates
0.0.0.0 is an invalid An IP address of all zeros
IP address was entered.
Access level is The operator requested that
Operator. configuration options be
Configuration is loaded, but does not have
read-only. authority to edit them.
Cannot Save – no All of the login IDs being
Login IDs with Access saved have an access level
Administrator below Administrator.
Command Complete Action requested has
successfully completed.
Invalid Character A nonprintable ASCII
character has been
entered.
Invalid – Data Network-initiated loopback
Terminal Initiated was in progress when the
Loopback Active selection was made.
Invalid entry at cursor Invalid IP address for this
function.
Invalid Password Login is required and an
incorrect password or Login
ID was entered; access is
denied.
Invalid – [ Test ] The described test was
Already Active already in progress when
the selection was made.
August 2000
Monitoring and Troubleshooting
What To Do
Enter a valid, non-zero IP
address.
If configuration options are to be
edited, use a Login ID that has
Administrator authority.
Change the access level of at
least one Login ID to
Administrator so that
configuration changes can be
made. (Operator-level users
cannot make configuration
changes.) Save the Login IDs.
No action needed.
Reenter information using valid
characters.
No action needed.
Enter a valid IP address. See the
appropriate table in Appendix A,
Configuration Options, to
determine the permitted address
range for this field.
H
Enter the correct Login ID and
password combination.
H
Contact your system
administrator to verify your
Login ID and password.
H
Allow test to continue.
H
Select another test.
H
Stop the test.
7-7