Table of Contents
Advertisement
5.7 Additional functions.
Lock mode
The lock mode is to protect the children from
any problems in case of careless use. When the
lock mode is activated, no button works.
-> To activate the lock mode, touch and h o l d t
h e lock button for 5 seconds. To deactivate the
lock mode, touch and h o l d t h e lock button
for 5 seconds.
-> When the lock mode is activated, the lock icon
lights up and a "beep" sounds.
ECO mode
The ECO function helps to save energy with a light
sensor of the equipment's environment.
When the lighting dims at night, the unit automa-
tically stops heating and cooling and lowers the
brightness of the control panel light.
-> To activate the ECO mode, touch and h o l d the
QUANTITY button for more than 5 seconds.
Then, it will be activated after the dispensing indi-
cator flashes blue 3 times and the "beep" sounds
2 times.
-> To deactivate the ECO mode, touch and hold the
QUANTITY button for more than 5 seconds.
Then, it will be activated after the dispensing indi-
cator flashes white 3 times and the "beep" sounds
3 times.
6. HOW TO ACCESS THE FILTERS
Before changing the filters, close the inlet valve
and depressurize the circuit by touching the
DISPENSING icon. Unplug the equipment from the
power supply.
Pull the drip tray to remove it. Remove the front
cover by pulling it down slightly and then tilting
the top outwards.
Tilt the filter by pulling it out at the bottom.
Remove the filter by turning it clockwise. Remove
the protective cap from the new filter and insert
it into the head by turning it counterclockwise.
Regardless of the ECO mode, the brightness of
the control panel light will be lowered when dar-
kness is detected in the equipment environment,
to avoid glare.
Activate/deactivate sound
By touching the lock button, the sound can be
turned on and off. Touch the lock button 3 times
in a row to deactivate the sound, and if you touch
the lock button 3 times in a row again, the sound
will be activated.
Change of default water dispensing setting.
The most frequently used water type can be set
as the default dispensing mode for more conve-
nient use.
By touching the AMBIENTE button for 5 seconds,
you can change the default setting of the dispen-
sing mode.
-> To set the default cold water.
Touch the ENVIRONMENT button for more than 5
seconds.
Then, the cold water button flashes 2 times with
a "beep" sound 2 times, and the cold water will
have been set by default.
-> To set the default ambient water.
-> Touch the ENVIRONMENT button for more than
5 seconds.
->Then, the room water button flashes 2 times
with a "beep" sound 2 times, and the room water
will be set to default.
Open the inlet valve and plug in the equipment to
the electrical supply. Rinse the filters by running
more than 10 liters of water at room temperature.
13
Advertisement
Table of Contents
