Kinetico Columbia Aqua FC-510 User Manual And Service Manual page 11

5.4 How to extract water from the equipment
Extract ambient water.
1) Touch the "AMBIENT" button to select the am-
bient water mode. (There is no need to touch the
ambient water button if ambient water is set as
the default setting).
2) Touch the "dispense button" to dispense room
temperature water. While dispensing water, the
dispensing indicator flashes.
Extract cold water.
1) Touch the COLD button for 3 seconds to ac-
tivate the cold water function. If the cold water
function is active, the indicator will be lit. Before
activating the cold water function, let the water
flow by touching the cold water button without ac-
tivating it to remove air from the circuit.
At start-up, it takes 1 hour to reach the tempera-
ture for dispensing cold water after activating the
function.
2) Touch the COLD button to select cold water
mode. The dispensing indicator will change to blue.
If the dose has not been selected, 120 ml of wa-
ter will be dispensed by touching the "dispense
button" once.
3) If you touch and hold the "dispensing button",
the dispensing indicator flashes white and am-
bient water comes out while you keep touching
the "dispensing button" up to 1500 ml.
3) After touching the COLD button, if you touch
the "dispense button" within 5 seconds, cold wa-
ter will come out and the dispense indicator will
flash blue.
If the dose has not been selected, 120 ml of wa-
ter will be dispensed by touching the "dispense
button" once.
4) Cold water will also be dispensed while tou-
ching and holding
11