Table of Contents
Advertisement
5.6 How to select the amount of water to be dispensed
Extract hot water.
1) Touch the HOT button for 3 seconds to activate
the hot water function. If the hot water function is
activated, the hot water indicator will be on.
Before activating the hot water function, let the
water run by touching the cold water button wi-
thout activating it to remove air from the circuit.
2) Touch the HOT button to select the hot water
mode. The dispensing indicator will change to red.
5.5 How to select the dispensing dose.
Touch the QUANTITY CONTROL button to select
the desired dose. If no dose is selected, 120 ml will
be dispensed by default.
By touching the QUANTITY CONTROL button once,
550 ml will be dispensed.
By touching the QUANTITY CONTROL button twice,
1500 ml will be dispensed.
By touching the QUANTITY CONTROL button 3 ti-
mes, 120 ml will be dispensed.
Once the extraction is finished, it returns to the
default dose (120 ml). While a dose is being dis-
pensed, you can stop the extraction by touching
the "dispense button" again.
Data sheet
3) After touching the HOT button, if you touch
the "dispense button" within 5 seconds, hot wa-
ter will come out and the dispense indicator will
flash red.
If the dose has not been selected, 120 ml of wa-
ter will be dispensed by touching the "dispense
button" once.
Use caution when dispensing hot water to avoid
scalding.
5.6 How to use the BOOST function.
It is an additional heating device, this function
heats the water up to 95ºC in 1 minute. The usual
hot water temperature without the BOOST func-
tion is 85ºC.
1) Touch the hot water button 2 times conti-
nuously. The additional heating will be active with
the BOOST indicator flashing and a "beep" will
sound. Once the temperature of 95°C is reached,
the heating process is automatically terminated
and the BOOST indicator remains illuminated.
It takes approximately 1 minute to complete the
additional heating process.
The time may vary depending on the initial tem-
perature.
The BOOST function is deactivated after each
use, and needs to be reactivated when required.
When the BOOST function is active, it can be de-
activated by touching the water button twice.
2) If hot water is selected after the BOOST func-
tion has been used, water may be dispensed at a
higher temperature (95ºC) than usual (85ºC).
Be careful when dispensing hot water to avoid
burns.
Advertisement
Table of Contents
