Is It Time For A Filter Change; Changing Your Kube's Filters - Kinetico Kube Manual

Is it Time for a Filter Change?

Kube's patented PureMometer® filter life monitor tells you when to change your filters based on
true water usage. No more wondering or worrying about using exhausted filters. Once the colors in
the window gradually change from blue to white to red, you will know it's time to replace them. The
estimated filter life span is approximately six months, depending on your usage. For replacement
filters, please visit your local retailer where you purchased your Kube or visit
NOTE: Cartridges must be changed every 12 months even if indicator is not showing red.
Brand New Filters:

Changing Your Kube's Filters

1
By-pass Your Kube
Turn the blue by-pass
knob until the white
indicator points to
the by-pass icon
3
Empty Tray
Slide the bottom tray out
and empty it in the sink.
Replace the tray into system.
TIP: Remember to empty the
tray after every filter change
as well as each time you put
Kube into by-pass mode.
5
Open Your Faucet
Turn on the cold
water at your faucet.
7
Flush Cold Water
Let water continue to run out of faucet for about
five minutes to activate your filter cartridges. After
five minutes turn off your faucet. Wait 10 minutes
and then turn the cold water back on for another
3 minutes. After 3 minutes turn off your faucet.
Note: Once again after every cartridge change you will want to clean the
filter screen on your faucet and empty the drip tray at the bottom of the unit.
Still Going Strong:
.
2
Remove Filters
Remove exhausted cartridges by twisting them
counterclockwise and then pulling them straight
out. The cartridges will not come out unless the
knob is turned to by-pass and the tabs are
aligned. They should be easy to remove— don't
force them. Keep both cartridges upright after
removal from the system to prevent water from
pouring out. Place used cartridges in the sink to
drain. TIP: When removing cartridges- There is a
small pressure lock, so once cartridge is turned
to the left, jiggle slightly and gently while pulling
toward you.
4
Install New Filters
To install your new filters, align the
tabs on the cartridge body with the
tab holes on the face of Kube. Fully
insert cartridge and then twist clockwise
to lock in place. The raised area on the cartridge cap should
be lined up with the lock icon
not turn unless both cartridges are completely installed.
6
Put Your Kube to Work
Turn the blue by-pass knob until the white
indicator points to the filtered water icon
TIP: The knob will not turn unless both
cartridges are completely installed.
www.kubewater.com.
Time to Replace Filters:
(red)
. The blue by-pass knob will
9