Table of Contents
Advertisement
Cables You Need
Each of the three POTS Splitter card interfaces requires a 50-conductor cable with
a 50-pin Telco connector:
T
T
T
Use a minimum of 24 AWG (0.205 mm
Preparation
The installation location should be well ventilated, clean, and free of environmental
extremes. Allow clearance at the front of the POTS splitter chassis to provide
access to the cables.
Read the
Tools Required
T
T
T
POTS Splitter Card Package Checklist
Verify that your POTS splitter card package contains the following:
6051-A2-GZ40-10
DSL interface connects to the DSL PORTS connector of a BitStorm 4800.
The 24-port BitStorm 4800 has one DSL PORTS connector on its rear panel,
and the 48-port BitStorm 4800 has two connectors.
Loop interface connects to the in-building POTS and ADSL customer
premises equipment (CPE).
PSTN interface connects to the PBX or PSTN.
Important Safety Instructions
A small #1 or #2 Phillips screwdriver to tighten the POTS splitter card
fasteners.
A large #3 or #4 Phillips screwdriver to install the chassis into a rack.
A flat-blade screwdriver to install the chassis grounding wire.
BitStorm 6051 POTS splitter card
Plastic bag with three of each item:
— Plastic tie-wrap anchors
— #4-40 x 1/4 screws
— #4-40 x 1/4 jack screws
— 8 cable tie wraps
July 2002
2
).
on page 17.
3
Advertisement
Table of Contents
