Table of Contents
Advertisement
Installing the POTS Splitter Card
Procedure
To install a POTS splitter card into the POTS splitter chassis:
6051-A2-GZ40-10
HANDLING PRECAUTIONS FOR
!
STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.
1. Remove the slot filler panel, if necessary, by loosening the quarter-turn
fastener on either side. Keep filler panels in all unused slots.
2. Slide the POTS splitter card into the chassis.
3. Tighten the quarter-turn fastener on each side of the faceplate of the POTS
splitter card.
POTS Splitter
6-Slot Chassis
Filler
TM
Panel
1/4-Turn
Fastener
DSL Interface
Loop Interface
PSTN Interface
July 2002
1/4-Turn
Fastener
02-17156
11
Advertisement
Table of Contents
